Primeplus is a highly advanced styrene butadiene polymer designed to prime, stabilise and seal substrates prior to the application
of Tilemaster tile adhesives and self levelling compounds. Primeplus increases the adhesion and prolongs the working time
of tile adhesives and self levelling compounds. Primeplus can be used on both absorbent and non-absorbent surfaces, internally
and externally. Available in 1L bottles - 1 litre applied neat will cover 10m². Diluted with 3 parts water, 1 litre will cover 40m². Applied as a slurry coat, 1
litre will cover 18m²
Underfloor Heating Systems: When tiling onto existing underfloor heating you must switch the heating off 48 hours prior to tiling to allow the substrate
to cool sufficiently. When tiling has been completed allow 1 week for full cure of tile adhesive and grout before switching
the heating on. When doing so, start with a low temperature and gradually increase the temperature on a daily basis by no
more than 2°C per day. When tiling on to a new electric element underfloor heating system, Tilemaster Adhesives strongly recommend
embedding the electric underfloor heating mat/element into a self levelling compound such as Levelflex or Rapid Level 30
in order to protect the heating element and to leave a perfect surface on which to apply tiles. Again, allow one week for
full cure before switching the heating on, start with a low temperature and gradually increase the temperature on a daily
basis by no more than 2°C per day.
Underfloor Heating Screeds: should be commissioned prior to tiling. Turn on the heating system at a low temperature and heat the screed gradually by
no more than 5°C per day until a maximum temperature of 25°C is achieved. Maintain this temperature for 3 days and then switch
the heating off 48 hours prior to tiling to allow the substrate to cool sufficiently. Alternatively in cold conditions, reduce
the temperature of the screed to below 15°C prior to tiling. When tiling has been completed allow 1 week for full cure of
tile adhesive and grout before switching the heating on. When doing so, start with a low temperature and gradually increase
the temperature on a daily basis by no more than 2°C per day.
Features:
- Wall & floor primer for absorbent & non-absorbent surfaces
- 1 litre applied neat will cover 10m². Diluted with 3 parts water, 1 litre will cover 40m². Applied as a slurry coat, 1 litre
will cover 18m²
- Designed to prime, stabilise & seal substrates
- Increases the adhesion of tile adhesives & levellers
- Prolongs the working time of tile adhesives & levellers
- Pigmented for ease of application
- Water based
Specifications
Manufacturer | Tilemaster Adhesives |
---|---|
Model | Primer |
Condition | New |
Range | Tilemaster Adhesives |
Colour | Light Green |
Prime Plus Primer In Litres | Prime Plus Primer 1.0L |
Pack Sizes | 1 Litre & 5 Litre Bottles |
Coverage | 1 litre applied neat = 10m², 1 litre diluted with 3 parts water = 40m² |
Application Temperature | Between 5°C and 35°C |
Drying Time Before Tiling | 30-45 Minutes in ideal conditions |