ThermoSphere's 25m roll of galvanised steel fixing profile is used to hold the heating cables in place. Can be mechanically fixed to timber or concrete substrates.
An Installation Must Have! Used for testing the resistance of heating mats/cables before, during and after installation. It can also be used round the house for checking fuses/circuits.
An Installation Must Have! An alarm will sound and alert you when you have damaged the heating cables of the underfloor heating system – Saving you time, money and effort.
The easy-to-use kit contains all necessary tools to repair the cables if they have been cut straight through or if a small section is damaged. Cheaper than replacing a heating mat.
For use with PE01, PE02 and 10K NTC resistance thermostats. This floor sensor can be used to measure air and floor temperature. Supplied with a 3 meter cable.
This sensor can be used to measure air and floor temperature. Supplied with a 3 meter cable and can be extended up to 20 meters if required. Resistance value of 10K NTC.
Used to discreetly measure air temperature. Compatible with 10K NTC rated thermostats that accept remote sensors or have remote sensor feature. Cable length of 2 meters.
50m roll of 50mm wide, premium duct tape. Ideal for use when adhering heating cables and/or heating mats to substrate and to keep cables/ends down when self-levelling.
A 40 amp contactor would be required for use when the total load of the heating exceeds 3.6kw (3600w) when using electric underfloor heating. Available in 20A or 40A.
This plastic contactor is suitable for use with the 20 amp and 40 amp FuseBox contactors supplied by Purely Electrique. They come with an IP40 rating and are 8mm x 14mm x 6mm.